Planet VC-201A Instrukcja Użytkownika

Ethernet over VDSL2 ConverterVC-201A / VC-204User’s Manual

101.4 SpecicationsProduct VC-201A VC-204Hardware SpecicationPorts10/100Base-TX1 RJ-45, Auto-negotiation and Auto-MDI/MDI-X4 RJ-45, Auto-negotiation

11Performance*(Down Stream / Up Stream)Asymmetric Mode200m -> 100/55Mbps 600m -> 70/40Mbps 1000m -> 45/15Mbps1400m -> 30/6Mbps 400m ->

122. Hardware DescriptionThe VC-201A / VC-204 provides 2 RJ-11 ports for voice connection (like telephone) and for network line connection.Th

13n VC-204 Front PanelFigure 2-2: VC-204 front panel 2.1.1 LED indicators for VC-201AThe rich diagnostic LEDs on the front panel can provide

14n 10/100Base-TX PortLED Color FunctionLNK/ACTGreenLit Indicate that the port is link up.BlinkIndicate that the Converter is actively sending or rece

15n VDSLLED Color FunctionACT GreenLitIndicate that the VDSL link is established.Fast BlinkIndicate that the VDSL link is at training status(about 10

162.2 The Rear PanelThe rear panel of the Ethernet Over VDSL2 Converter is shown as below.n VC-201A Rear Panel1 2 3 4Figure 2-3: VC-201A re

17DIP-1 DIP-2 DIP-3 DIP-4Mode Channel Band Plan SNROFF CO Interleave Symm 9dBON (default) CPE Fast Asymm 6dBCO / CPEu CO (Central Ofce) – the Ma

18Target SNR (Signal Noise Ratio) Marginu When xed SNR margin is selected, the system will main-tain the SNR margin at 9 dB across all usabl

193. Installing and Using VDSL Converter 3.1 Install the Ethernet Over VDSL2 ConverterThe Ethernet Over VDSL2 Converter does not require any s

TrademarksCopyright © PLANET Technology Corp. 2009Contents subject to revision without prior notice.PLANET is a registered trademark of PLANET

203.1.1 VC-201A / VC-204 LAN to LAN connectionTwo sets of the Ethernet Over VDSL2 Converters could be used to link two local Area networ

21to the telephone line system, on the other hand, need to install a Slave (VC-201A / VC-204 CPE) converter on the individual client s

226. Connect telephone to the PHONE port.7. Connect Ethernet port to PC Network Interface Card (NIC) via regular Cat. 5 cable. Figure 3-3: Connecting

23Figure 3-4: Connecting Multiple PCs to an Ethernet LAN NotePlease refer to your Ethernet device User’s Manual for the device’s set up information.

243.3 Chassis Installation and Rack Mounting (VC-201A)To install the Ethernet over VDSL2 Converter in a 10-inch or 19-inch Converter Cha

254. POWER INFORMATIONThe power jack of VC-201A / VC-204 is with 2.5mm in the central post and required +5VDC power input. It will conform

265. TroubleshootingSYMPTOM: VDSL LNK LED does not lit after wire is connected to the VDSL port.CHECKPOINT: 1. Verify the length of the wire con

276. FAQQ1: What voltage that VC-201A / VC-204 used?A1: 5VDC, 2AQ2: What is VDSL2?A2: VDSL2 (Very High-Bit-Rate Digital Subscriber Line 2),

28Q6: What is SNR and what’s the effect?A6: In analog and digital communications, Signal-to-Noise Ratio, often written SNR, is a measure

regulations for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pr

TABLE OF CONTENTS1. Introduction ... 5 1.1 Checklist ...

51. Introduction1.1 ChecklistCheck the contents of your package for following parts:VC-201A / VC-204Power AdapterRJ-11 Telephone line User’s ManualIf

6PLANET’s VDSL2 Converter solution provides a much cheaper replacement and smooth migration for existing Long Reach Ethernet (LRE) netwo

7LAN1LAN2VC-204/CO VC-204/CPEUp to 1.6kmEthernet over VDSL and Telephone NetworkMain office/PBX, Telco CO, wire closetVDSL2Telephone wireLAN1LAN2VC-20

8LAN2RouterLAN1UP to 1.6kmEthernet over VDSL and Telephone NetworkMain office/PBX, Telco CO, wire closetVDSL2 Switch(Multi-port CO)VC-204/CPEVC-204/CP

91.3 Key FeaturesThe Ethernet Over VDSL2 Converter provides the following key features:Cost-effective VDSL2 CO/CPE bridge solutionOne box desi