NAT Redirection
Translates private IP addresses into public addresses.
Auto-configuration: The public address is automatically designated by the
system.
A designated IP: The public address is manually designated by the IT
administrator.
Max. Downstream & Upstream Bandwidth
The IT administrator must define a proper bandwidth for each of them in order
that the device may use it as a basis for operating.
Disconnect if idle for…minutes
The device may be configured to automatically disconnect when idle for a period
of time upon using PPPoE connection. The time unit is minute; enter a number
from 1 to 99,999 inclusive as the basis of disconnection, or “0” to stay
connected.
Connection Type (As Interface Type set to DMZ)
Please refer to “Connection Type (As Interface Type set to LAN)”.
Bonding
Network Bonding allows you to aggregate the bandwidth of multiple interfaces
into a single connection.
Bonding Interface
Configuring the interface. (LAN, WAN or DMZ)
Bonding Mode
The three available modes are as follows:
Round-Robin: Transmits packets in sequential order from the first available
slave port through the last. (Prerequisite: A switch that supports port
trunking.)
Active-Backup: Only one slave port in the bond is active; a different slave
port becomes active only if the active one fails.
IEEE 802.3 ad Link Aggregation: Transmits and receives packets using all
slave ports in one active aggregator. (Prerequisite: A switch that supports
IEEE 802.3ad Dynamic link aggregation.)
Komentarze do niniejszej Instrukcji